Steer Smarts 78066001 – Jeep Drag Link Top Mount Assembly High Steer or Drilled-Out OE Knuckle Yeti XD For 07-18 Wrangler JK

2007-2018 Jeep Wrangler JK Yeti XD JK Drag Link Top Mount Assembly (High Steer or Drilled-Out OE Knuckle). A Minimum Lift Height Of 3-3.5 inch (And Correct Bump Stop) Is Required For A Top-Mount Drag Link.

Track Bar Relocation Bracket Required For Top Mount Drag Link To Maintain Proper Parallel Geometry Track Bar And Drag Link

A minimum of 17 inch wheels is recommended. 16 inch wheels with a maximum 4.5 back spacing might fit but not guaranteed. The YETI XD Top Mount Draglink for a high steer or drilled-out stock knuckle was designed to be a complete bolt-on for JK’s that have already been modified for a flipped draglink 30mm 2-1/2 Ton ball joints designed specifically for the JL and JT.

• Steel on steel bearings provide exceptional ball joint wear resistance and robustness.
• Powder coat over E-coat for a long lasting appearance under harsh conditions.
• Large 1 1/4 inch rolled threads at tie rod adjuster and draglink ends provide significantly increased strength over the original equipment threads.
• Adjuster tube designed with right hand and left hand threads for quick and easy adjustment when installed on the vehicle.